Simulation of mid-spatials from the grinding process

M. Pohl; R. Börret

doi:10.2971/jeos.2016.16010

Journal of the European Optical Society - Rapid publications, Vol 11 (2016)

Simulation of mid-spatials from the grinding process

M. Pohl, R. Börret

Abstract

This paper focuses on the simulation of the creation of mid-spatial frequencies (mid-spatials) during the grinding process of optical components. The goal is to simulate this generation process and determine the correlating grinding parameters for mid-spatials. On this base, grinding parameters which lead to less mid-spatials could be determined.

Full Text: PDF

Citation Details

Cite this article

References

G. Yu, H. Li, and D. Walker, ”Removal of Mid Spatial-Frequency Features in Mirror Segments,” J. Eur. Opt. Soc.-Rapid 6, 11044, 2011

J. DeGroote, B. Light, B. Savage, B. Wiederhold, and M. Mandina, ”VIBE™ finishing to remove mid-spatial frequency ripple,” OSA Publishing 2010, OWE2 (2010).

Y. F. Dai, F. Shi, X. Q. Peng, and S. Y. Li, ”Restraint of mid-spatial frequency error in magneto-rheological finishing (MRF) process by maximum entropy method,” Sci. China Ser. E 52, 3092–3097 (2009).

R. Boerret, J. Burger, A. Bich, C. Gall, and T. Hellmuth, ”Research on fabrication of aspheres at the Center of Optics Technology (University of Applied Science in Aalen),” Proc. SPIE TD03, 20–23 (2005).

C. Vogt, H. Adelsberger, F. Schneider, T. Koller, S. Draxinger, S. Sinzinger, R. Rascher, et al., ”Dwell time assisted grinding,” in Proceedings of 2nd EOS Conference on Manufacturing of Optical Components (EOSMOC 2011), (EOS, München, 2011).

C. Vogt, R. Rascher, J. Mazal, R. Börret, R.-D. Lohner, and T. Tawakoli, ”The cause of structures on ground shapes,” in Proceedings of 3rd EOS Conference on Manufacturing of Optical Components (EOSMOC 2013), (EOS, München, 2013).

C. Heinzel, D. Grimme, and A. Moisan, ”Modeling of Surface Generation in Contour Grinding of Optical Molds”, in CIRP Annals - Manufacturing Technology 55(1), 581–584 (2006).