Flat-gain wide-band erbium doped fiber amplifier by combining two difference doped fibers

B. A. Hamida; S. M. Azooz; A. A. Jasim; T. Eltaif; H. Ahmad; S. Khan; S. W. Harun

doi:10.2971/jeos.2015.15015

Journal of the European Optical Society - Rapid publications, Vol 10 (2015)

Flat-gain wide-band erbium doped fiber amplifier by combining two difference doped fibers

B. A. Hamida, S. M. Azooz, A. A. Jasim, T. Eltaif, H. Ahmad, S. Khan, S. W. Harun

Abstract

A new erbium-doped fibre amplifier (EDFA) is demonstrated using a combination of newly developed Erbium Zirconia co-doped fiber (Zr-EDF) and the commercial silica-based Erbium-doped fiber (Si-EDF) as the gain medium. Both fibers have a very high concentration of erbium ion. A compact amplifier operating in C-band region is firstly reported using a double-pass configuration. It is shown that average gains of the proposed Zr-EDF amplifier are obtained at approximately 18 dB with a gain variation of ±2 dB within C-band region. A flat-gain and wide band operation is achieved by configuring the amplifier in two stages comprising a 2 m long Zr-EDF and 9 m long Si-EDF optimised for C- and L-band operations, respectively, in a double-pass parallel configuration. A chirp fibre Bragg grating (CFBG) is used in both stages to ensure double propagation of the signal and thus to increase the attainable gain in both C- and L-band regions. At an input signal power of 0 dBm, a flat gain of 15 dB is achieved with a gain variation of less than 0.5 dB within a wide wavelength range from 1530 to 1605 nm. The corresponding noise figure varies from 6.2 to 10.8 dB within this wavelength region.

Full Text: PDF

Citation Details

Cite this article

References

A. E. A. Mohammed, and A. N. Z. Rashed, ”Ultra wide band (UWB) of optical fiber Raman amplifiers in advanced optical communication networks,” J. Media Commun. Stud. 1, 56–72 (2009).

S. W. Harun, N. Tamchek, P. Poopalan, and H. Ahmad, ”Doublepass L-band EDFA with enhanced noise figure characteristics,” IEEE Photon. Technol. Lett. 15, 1055–1057 (2003).

S. W. Harun, N. K. Saat, and H. Ahmad, ”An efficient S-band erbiumdoped fiber amplifier using double-pass configuration,” IEICE Electron. Expr. 2, 182–185 (2005).

X. Wang, Q. Nie, T. Xu, X. Shen, S. Dai, and N. Gai, ”Tm3+-doped tellurite glass with Yb3+ energy sensitized for broadband amplifier at 1400–1700 nm bands,” J. Rare Earth. 26, 907–911 (2008).

A. J. G. Ellison, J. E. Dickinson, D. E. Goforth, D. L. Harris, J. T. Kohli, J. D. Minelly, B. N. Samson, et al., ”Hybrid erbium silicate conventional-band fiber amplifier with ultra-low gain ripple,” in Proceedings to Optical Amplifiers and their Applications, NW2 (Optical Society of America, Nara, 1999).

P. F. Wysocki, N. Park, and D. DiGiovanni, ”Dual-stage erbiumdoped, erbium/ytterbium-codoped fiber amplifier with up to +26 dBm output power and a 17 nm flat spectrum,” Opt. Lett. 21, 1744–1746 (1996).

E. Desurvire, D. Bayart, B. Desthieux, and S. Bigo, Erbium-doped fiber amplifiers, device and system developments (John Wiley & Sons Inc., New York, 2002).

M. Kakui, T. Kashiwada, K. Nakazato, M. Onishi, C. Fukuda, M. Shigematsu, and M. Nishimura, ”Design optimization of hybrid erbium-doped fiber amplifiers for WDM transmission systems,” Opt. Fiber Technol. 3, 123–133 (1997).

J. Nilsson, and B. Jaskorzynska, ”Alternating cascade of spectrally different erbium-doped fiber amplifiers for link-loss-insensitive long-haul WDM transmission,” J. Lightwave Technol. 17, 434–444 (1999).

A. Bjarklev, ”Hybrid erbium-doped fiber for gain flattened operation,” Opt. Fiber Technol. 3, 72–76 (1997).

S. W. Harun, and H. Ahmad, ”Gain clamped two-stage doublepass L-band EDFA with a single fibre Bragg grating,” Chinese Phys. Lett. 21, 1954–1957 (2004).

L. Bigot, G. Le Cocq, and Y. Quiquempois, ”Few-mode erbiumdoped fiber amplifiers: a review,” J. Lightwave Technol. (2015) article in press.

X. S. Cheng, R. Parvizi, H. Ahmad, and S. W. Harun, ”Wide-band bismuth-based erbium-doped fiber amplifier with a flat-gain characteristic,” IEEE Photon. J. 1, 259–264 (2009).

R. Schermer, W. Berglund, C. Ford, R. Ramberg, and A. Gopinath, ”Optical amplification at 1534 nm in erbium-doped zirconia waveguides,” IEEE J. Quantum Elect. 39, 154–159 (2003).

H. Ahmad, K. Thambiratnam, M. C. Paul, A. Z. Zulkifli, Z. A. Ghani, and S. W. Harun, ”Fabrication and application of zirconia-erbium doped fibers,” Opt. Mater. Express 2, 1690–1701 (2012).